Ross Synergy 100, Руководство по установке, Страница: 41 / 246

Synergy 100 Installation Guide (v16.10-S100) Installation • 2–7
Frame, Front View
The following figure illustrates the front of the frame, with the door removed.
Synergy 1 SD Frame, Front View
Following are descriptions of each front component.
1. Frame CPU Board
The Frame CPU Board provides all the electronics required for the Synergy 1 SD
Switcher. The board also houses several “daughter” boards for options such as Squeeze
& Tease 2D or WARP , Ultimatte Insider , or Floating Border Generator .
2. Power Supply Lock Down Plate
The power supply is held in place with a single lock-down plate that is secured with two
screws. These screws must be loosened and the lock-down plate moved up in order to be
able to remote the power supply.
3. Power Supply Handle
A small handle is provided to assist in removing and inserting the power supply. The
tray houses the power supply and frame fan. For chassis cooling, note that air flows in
from the sides of the frame, across the circuit boards and out the rear exhaust port.
4. Fan Fail LED
The FAN FAIL LED, when lit, indicates that the fan is drawing too much current or has
stopped turning.
5. Power Fail LED
The POWER FAIL LED, when lit, indicates that the power supply has failed or is not
connected properly.
1) Frame CPU Board
2) Power Supply Lock Down Plate
3) Power Supply Handle 4) Fan Fail LED
5) Power Fail LED
6) Power On LED 7) Power Switch
8) Fuse
Warning
Hazardous
Voltage
When the power supply is inserted into the frame, it mates with male
power pins that carry
live voltage if the frame is plugged in. All power
must be disconnected before servicing. Caution — do not insert your
fingers into the power supply slot when the unit is plugged in!
FUSE
T4A/250V
POWER
FAN
FAIL PWR
FAIL PWR
ON
1
4
5
6
7 8 2
3
TO REDUCE THE RISK OF
FIRE REPLACE WITH SAME
FUSE AND RATING
CAUTION: