Ross Synergy 100, Руководство по установке, Страница: 174 / 246

9–4 • Completing Setup Synergy 100 Installation Guide (v16.10-S100)
• Individual 3D Wipes Registers
This category stores and recalls individual 3D wipes that are present on the switcher. If
you have the Squeeze & Tease WARP option installed, the pre-programmed wipes on
the board can be individually saved to a storage device, and then over-written by a 3D
wipe that you have created. When saved on a storage device, the default filename
STSEQXX.SEQ
(where XX is the wipe number from 00 to 99) is used. Refer to the
Synergy 100 Squeeze & Tease 3D/WARP Owner’s Guide for information on Squeeze
& Tease WARP .
The file storage and recall system is accessible via the Disk Menu . This menu provides complete
flexibility with regard to registers. You can independently store or recall individual categories as
desired (without affecting other files) or you can store
all categories at once.
Even though all the data listed above is stored in the switcher’s non-volatile “flash” memory, it is
always wise to keep an archive or “engineering” storage device on hand that contains your important
setups and configurations. Not only does this provide security in case you need to re-program the
switcher, but it also allows you to have a variety of switcher
files available (on multiple floppy disks
or USB keys), should you need to load different configurations — for different clients or different
production situations.
Notes on Using a USB Key
This option replaces the floppy disk drive on the control panel, and supports industry standard USB
keys. Once the option is installed, you can store and recall complete switcher setups including
memory functions, switcher personalities, installation registers, and more, to a USB key.
Consider the following notes when using a USB key:
• Write protect should be disabled on any USB key.
• All Synergy files must be stored in the Root directory of the USB key.
• Only DOS or Windows™ partitions in the USB key directory are supported.
• You must wait 5 seconds after inserting the USB key into the USB port before you can
save or recall files.
• A delay can be expected when saving files to a USB key with more than half of the
available memory allocated.
• You may receive a “ USB UPG FAIL ” error message when the Synergy 100 control
panel is powered on. Should you receive this error message, contact Ross Video
Technical Support for instructions on how to correct the error.
Note One 1.4 MB high-density floppy disk stores one complete set of
registers, as outlined above.
Important
A decrease in performance will result from storing more than one set
of Synergy files on your USB key.