Ross Synergy 100 MD, Руководство оператора

Страница: 173 / 402

Synergy 100 MD Operator’s Manual (v7.2 MD-S100) Peripheral Control and More • 10–3
Using the Aux Bus
The Synergy 100 MD switcher provides 10 Aux Buses that can be used to route video to monitors,
Still Stores, as well as other devices. The video sources for these Aux Buses are selected using the
Key Bus and the special Preset Bus crosspoints on the control panel.
Before you attempt to use the Aux Bus, ensure that each Aux Bus is properly connected to the desired
external devices. Consult with your facility engineer, who can provide you with an Auxiliary
Output Worksheet that lists the Aux Bus outputs and their destinations.
Use the following procedure to assign a crosspoint to an Aux Bus.
1. Enter Aux Bus mode as follows:
• Press and hold the left SEL button in the Effects Control Group until AUX#
appears on the display in the Effects Control Group . The “ # ” represents the Aux
Bus that is currently selected.
Effects Control Groups
2. Press the pattern button in the Effects Control Group that corresponds to the Aux Bus
that you want to assign a crosspoint output to. You can select between
AUX0
through
AUX9
.
B USY
E F F E C T S C O N T R O L M A T T E S S Y S T E M C O N T R O L
EDIT
SEL BACK MENU SEL CNTR
DVE
ON AIR
KEY1
KEY2
DSK
PGM
PST
ON AIR ON AIR ON AIR ON AIR
ON AIR
ASPECT
HUE/
TRANSP
GAIN
CLIP
HUE
SAT
LUM CLIP GAIN SOFT BORDER
SEL
REV
MEM
FLY
KEY
SELF
KEY
BLACK SHIFT
SHIFT
SHIFT
BLACK
BLACK
AUTO
SELECT
MASK
KEY
INVERT
PST
PATT
CHROMA
KEY
MATTE
FILL
KEY2
KEY
MEM
MATTE
FILL
SELF
KEY
AUTO
SELECT
MASK
BKGD KEY1 KEY2
DISS
CUT
WIPE
AUTO
TRANS
TRANS
LIMIT
DSK
CUT
PST
BLACK
DSK
DISS
FADE
TO
BLACK
DVE
KEY
INVERT
CHAR
GEN1
CHAR
GEN2
DSK
PV
SHDW BORD OUTL ROTATE
ASPECT
5
0
6
1
7
2
8
3
9
100 10 1 4
D O W N S T R E A M K E Y E R
T R A N S I T I O N C O N T R O L
M A T T E S E F F E C T S K E Y E R S E F F E C T S C O N T R O L