Ross Synergy 100 MD, Руководство оператора

Страница: 169 / 402

Synergy 100 MD Operator’s Manual (v7.2 MD-S100) Memory and Disk Functions • 9–15
Recalling Registers
The Synergy 100 MD switcher allows you to recall all categories of registers from a storage device, or
you can recall the desired individual category.
Use the following procedure to recall registers from a storage device:
1. Navigate to the Disk Menu as follows:
• Press
MENU
to display the Main Menu .
• Press
5. Disk
to display the Disk Menu .
2. Press
0. Dest/Source
to display the Dest/Source Menu .
Dest/Source Menu
3. Select the storage device you want to use to store your registers to as follows:
• Press 0. Dest/Source .
• Use the
ª
and
©
buttons to select the storage device you want to use. You can
select between the following:
~
Hard Drive
— This option will allow you to recall the files from the internal
hard drive.
~
USB
— This option will allow you to recall the files from a USB Drive. You
must wait 5 seconds after inserting the USB Drive into the USB Port before
you can save or recall files. Refer to the section “
Notes on Using a USB
Drive ” on page 9–16 for further information.
4. Select a setup, or location, as follows:
• Press
1. Set Names
.
• Use the
ª
and
©
buttons to select the Setup you want to use. You can select from
SETUP (00)
to
SETUP (99)
.
5. Press
BACK
to display the Disk Menu .
Caution If you are going to recall any set of registers (e.g., memory), ensure
that your current on-line set of registers are stored to another storage
device or SETUP. If you have not stored them, they will be overwritten
when you recall the files.
MENU
Exit 100
Previous 10
Down SEL
Accept 1
Up
Dest/Source
0. Dest/Source
1. Set Names Hard Drive
SETUP(00)