Ross Synergy 100 MD, Руководство оператора

Страница: 111 / 402

Synergy 100 MD Operator’s Manual (v7.2 MD-S100) Keying • 7–5
• Use the
GAIN
knob to adjust the gain of the Key. The control acts on all Keys and
softens the Key edge, allowing you to adjust the way that the Key blends into the
background.
3. Key Assignment Section
The button in the Key Assignment Section allows you to toggle control of all Key
modifiers between the two Keys in the Effects Keyers Group .
• Toggle the
KEY2
button
On
(lit) to assign the Effects Keyers Group to Key 2 . To
assign the
Effects Keyers Group
back to Key 1 , toggle the
KEY2
button
Off
(unlit).
Downstream Keyer Group
The following figure illustrates the Downstream Keyer Group of the Synergy 100 MD control
panel:
Synergy 100 Downstream Keyer Group
1. Key Type Section
The Key Type Section provides two buttons that select the type of Key that will be
inserted over background video.
• Press
SELF KEY
to select a “Self” Key type, also known as a luminance Key. With
a Self Key, the luminance (or brightness) values of the Key source itself (as selected
on the
Key Bus ) are used to cut the hole.
The Key hole is filled with the same video signal as the Key cutter or the hole can
also be filled with color matte. Self Keys are often used to Key images from tape.
• Press
AUTO SELECT
to choose an “Auto Select” Key type, also known as a
linear Key.
Note
The
GAIN
function does not apply to Squeeze & Tease MD Keys.
Note
If you have the MultiDSK option installed, MultiDSK4 and
MultiDSK5 are not controlled from the Downstream Keyer Group .
Refer to the section “ MultiDSK Operation ” on page 7-35 for details.
1) Key Type Section
2) Key Modifier Sections 3) Border Controls
4) DSK PV Button
GAIN
KEY2
CLIP GAIN
KEY
MEM
MATTE
FILL
SELF
KEY
AUTO
SELECT
MASK
KEY
INVERT
CHAR
GEN1
CHAR
GEN2
DSK
PV
SHDW OUTL
BORD
D O W N S T R E A M K E Y E R
2
1
2 3
4
SELF
KEY
AUTO
SELECT