Ross Synergy 1, Руководство по обслуживанию

Страница: 63 / 240

Synergy 1 and Synergy 100 Maintenance Guide (v16-S1) Software Upgrades • 3–17
•
SW1
to
SW7
– These assignments are Reserved and must be left in their default
Down
positions.
•
SW8
– Preview Overlay . This switch controls the ability to remove the Preview
Overlay from the Preview outputs as follows:
~
Up
— Preview Overlay is removed from the Preview output and is displayed
on Aux 1 and Aux 2 outputs.
~
Down
— Preview Overlay displays on PV1 and PV2 outputs. This is the
default position.
5. DIP Switch 4
This 8-position DIP switch has the following system assignments (from left to right):
•
SW1
— This switch is Reserved . Leave in the default
Down
position.
•
SW2
— This switch is Reserved . Leave in the default
Down
position.
•
SW3
— Panel Type . Works with
SW4, SW5
and
SW6
.
•
SW4
— Panel Type . Works with
SW3, SW5
and
SW6
.
•
SW5
— Panel Type . Works with
SW3, SW4
and
SW6
.
•
SW6
— Panel Type . Works with
SW3, SW4
and
SW5
.
Refer to the table below for details.
• SW7 — Installation Enable . This switch determines the installation status of the
switcher:
~
Up — Access to installation features is restricted. However, you are permitted
to view the menus on the preview overlay. A message is displayed, directly
above the navigation help, that reads “
Warning: Installation settings are
locked .” If the user has attempted to change the installation in any way, the
following message appears:
Warning Message – Locked Installation Settings
DIP Switch 4 Positions
DIP Switch 4 Synergy 100 Synergy 1 GVG 100/110 Ross 210A/D Ross 216A/D
SW3 Down Down Down Down Up
SW4 Down Down Down Up Up
SW5 Up Down Up Up Up
SW6 Down Down Up Up Up
WARNING!
Installation settings are locked; the switcher
will now revert to its previously saved
installation settings.
10
Down 1
Up SEL
Accept
0. OK