Ross Synergy 1, Руководство по обслуживанию

Страница: 35 / 240

Synergy 1 and Synergy 100 Maintenance Guide (v16-S1) System Architecture • 2–11
The MLE includes the following outputs:
• Program — This output is routed to a rear-frame BNC output connector, to the Preview
Matrix, and also back into the crosspoint matrix.
• Preview — This output is routed to a rear-frame BNC output connector and to the
Preview Matrix.
• Clean Feed — This output is routed to a rear-frame BNC output connector and also
back into the crosspoint matrix.
• Aux 1 (Synergy 1 only) — This output is routed to a rear-frame BNC output connector
through the video switch.
• Aux 2 (Synergy 1 only) — This output is routed to a rear-frame BNC output connector
through the video switch.
Serializer Modules
Program , Preview , Clean Feed, Aux 1, and Aux 2 video each come out of the MLE as parallel 10-bit
data. These signals are then routed through small Serializer Modules (4000A-062) as shown below.
Serializer Module
Serializer Modules convert the parallel digital video data into the serial format, which can then be
routed via coax cables through your facility, or used internally in the Synergy’s crosspoint matrix.
The
crosspoint matrix requires that everything must be in the serial format. Thus any signal that is routed
to the crosspoint matrix must go through a Serializer Module , from any given output.
Note The Clean Feed has a dedicated BNC output, just like Program and
Preview , but DVE Send is only available to the outside world by
routing it into the video switch, and then out via an Aux Bus.
There is no DVE Send BNC output.