Ross Synergy 1, Руководство по обслуживанию

Страница: 152 / 240

9–10 • Calibration and Diagnostics Synergy 1 and Synergy 100 Maintenance Guide (v16-S1)
3. Test the fader as follows:
• Press
Normal
.
• Move the fader up and down.
• The position of the fader is shown both numerically (in hexadecimal) and
graphically. The number should range from
000
(up) to
FFF
(down), and the
number should be stable and jitter-free.
• If the number does not reach both limits, perform a calibration as described in the
the section “
Switcher Calibration – Synergy 1 ” on page 9–2.
This completes the procedure to to test the fader on the Synergy 1 control panel.
Joystick Test
The Joystick Test Menu allows you to test all three axis of the Joystick of the Synergy 1 panel.
Use the following procedure to test the Joystick:
1. Navigate to the Panel Diagnostics Menu 1-2 as follows:
• Press HOME (to display the Main Menu 1-2 )
• MORE (to display Main Menu 2-2 )
• Setup (to display the Setup Menu )
• Panel Diagnostics (to display Panel Diagnostics Menu 1-2 )
2. Press Joystick Test to display the Joystick Test Menu .
Joystick Test Menu
3. Test the Joystick as follows:
• Press Normal .
• Move the positioner up, down, left, right, and twist in both directions.
• The position of the fader is displayed both numerically and graphically. The number
should range from
0 (center) to 64 , and the number should be stable and jitter-free.
• If the number does not reach these limits, perform a calibration as described in the
the section “
Switcher Calibration – Synergy 1 ” on page 9–2.
This completes the procedure to test the joystick of the Synergy 1 control panel.
Note Contact Technical Support for details on each display value, or if a
problem with the fader is suspected.
Note
Contact Technical Support for details on each display value, or if a
problem with the joystick is suspected.