Ross Synergy 1, Руководство по обслуживанию

Страница: 146 / 240

9–4 • Calibration and Diagnostics Synergy 1 and Synergy 100 Maintenance Guide (v16-S1)
Switcher Calibration – Synergy 100
The Calibration Mode allows you to calibrate all analog controls on the switcher panel, including the
fader, the positioner and all knobs. In addition, the user is able to set the brightness levels of all panel
button LEDs.
Calibrating the Synergy 100 Switcher
Use the following procedure to calibrate the analog controls and adjust the brightness levels of the
LEDs for the Synergy 100 switcher:
1. Enter Calibration Mode by holding down the following three buttons at once:
• ROTATE
• SEL in the Mattes Group
• SEL in the System Control Group
The Panel Calibration Mode Menu is displayed on the Preview monitor.
Synergy 100 — Panel Calibration Mode Menu
Using pattern buttons 0 through 8 inclusive in the Effects Control Group , select the
button with the number that coincides with the desired option. The selected button will
light.
Caution
Use the Calibration Mode with caution.
Perform the calibration only when you suspect that there has been
“drift” in the knobs or the joystick, or that there is a “limit” problem
with a fader.
Important
If you select option
0. Knob/Fader/Positioner Calibration
, you
must calibrate all analog controls on your switcher. Failure to do so
will map a false limit into switcher memory for the control(s) that you
did not calibrate, thus preventing proper switcher operation.
Panel Calibration Mode
0. Knob/Fader/Positioner Calibration
2. Logo Brightness
3. Red Button LED Brightness
4. Orange Button LED Brightness
5. Green Button LED Brightness
6. Red Non-Button LED Brightness
7. Orange Non-Button LED Brightness
8. Green Non-Button LED Brightness
Press any button on lower panel to exit.
1. Overall LED Brightness Control