SideBox/SideBoxNet
Installation and Setup
The SideBox enclosure can be used with both the
Acuity
™
and Carbonite switchers. The SideBoxNet
enclosure is only supported by the Acuity
™
switcher
running software version 6.0 or higher.
The SideBoxNet enclosure comes pre-assembled with
a number of modules and includes the SideShotNet,
SideSlideNet, and SideStick. All of these product are
installed and connected to the switcher in the same
way, and only differ in setting up the actual module
itself.
Note:
Refer to your switcher documentation for information on
setting up each module.
Installation
SideBox and SideBoxNet can be installed onto a desk,
into the desk using the supplied mounting brackets, or
onto a standard VESA mount.
Desk Mounting
The enclosure can be mounted into a desk in either a
flat or sloped position. How you want the enclosure to
be positioned determines where the mount brackets are
installed.
Figure 1: In-Desk Mounting Options
If you are sitting the enclosure onto a desk you do not
need to install the mounting brackets.
Desk Cutout
The desk cutout size for the enclosure is the same if
you are mounting it in the flat or sloped position.
Figure 2: Desk Cutout Size
To Install the In-Desk Mounting Brackets
1.
Select the mounting option you want to use for
how the enclosure is installed.
2.
Remove the mounting screws from the side of
the enclosure for the mounting option you have
chosen.
Figure 3: Mounting Screws
3.
Install the mounting bracket onto the side of the
enclosure using the screws you just removed.
Figure 4: Mounting Bracket
4.
Repeat this procedure for the other side of the
enclosure.
VESA Mounting
The enclosure can be mounted onto a VESA FDMI
MIS-D 75 or 50, C Mounting Arm.
4802DR-304-08
©
2020 Ross Video Limited. Ross
®
and any related marks are trademarks or registered trademarks of Ross Video Limited. All other trademarks are the property of their respective companies. PATENTS ISSUED and PENDING. All rights reserved. No part of this
publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, mechanical, photocopying, recording or otherwise, without the prior written permission of Ross Video. While every precaution has been taken in the preparation of
this document, Ross Video assumes no responsibility for errors or omissions. Neither is any liability assumed for damages resulting from the use of the information contained herein.
