2–10 • Installation
GPI-100 User Manual (Iss. 06)
Software Upgrades
This section provides instructions for upgrading the software for your GPI-100 using DashBoard.
To upgrade the software on a GPI-100
1.
Contact Ross Technical Support for the latest software version file.
2.
Launch the DashBoard client on your computer.
3.
Display a tab for the card you wish to upgrade by double-clicking its status indicator in
the
Basic Tree View
.
4.
From the
Device
tab, click
Upload
to display the
Select File for upload
dialog box.
5.
Navigate to the
*.bin
upload file you wish to upload.
6.
Click
Open
and follow the on-screen instructions.
7.
Click
Finish
to start the upgrade.
8.
Monitor the upgrade.
• A
Upload Status
dialog enables you to monitor the upgrade process.
• The card reboots automatically once the file is uploaded. The card is temporarily
taken off line.
•
The reboot process is complete once the status indicators for the
Card State
and
Connection
return to their previous status.
Troubleshooting
If you encounter problems when upgrading your card software, verify the following:
• Ethernet cable is properly connected if you are uploading the file via a network
connection.
• The file you are attempting to load is a
*.bin
file that is for the card you are upgrading.
Operating Tip
— If you are running DashBoard version 2.3.0 or lower, you must
click
Reboot
in the
Device
tab to complete the upgrade process.
Содержание openGear GPI-100
Страница 1: ...GPI 100 VANC to GPIO Trigger Inserter Decoder User Manual...
Страница 6: ......
Страница 8: ...ii Contents GPI 100 User Manual Iss 06...
Страница 14: ...1 6 Introduction GPI 100 User Manual Iss 06...