DRA-8902 Series User Manual (Iss. 02)
Configuration • 3–7
To enable the alarm for an invalid input signal
1.
From the
Device View
, select the
Alarms
tab.
2.
To raise an alarm when an invalid input signal is detected, select the
Invalid Signal
check box in the
Input
area of the tab for the input you wish to monitor.
Alarms Tab
The
Input Status
fields in the
Signal
tab and the
Status
tab report when an invalid input
signal is detected on the corresponding Input BNC.
To enable the alarm for an invalid output signal
1.
From the
Device View
, select the
Alarms
tab.
2.
To raise an alarm when an invalid output signal is detected, select the
Invalid Signal
check box in the
Channel
area of the tab for the output you wish to monitor.
Alarms Tab — Invalid Output Signal Alarm Boxes
The corresponding
Output Status
field in the
Signal
tab reports when an invalid input
signal is detected.
Enabling the Failover Alarm
Enabling the Failover alarm allows the card to report when a loss of input has occurred and the
output channel automatically switched to the backup source specified in the section “
” on page 3-6. When the source is switched over, a failover message
displays in the
Output Status
fields of the
Signal
tab and the
Setup
tab. If the alarm is disabled,
the status fields do not report when the loss of input failover has occurred.
To enable the failover alarm
1.
From the
Device View
, select the
Alarms
tab.
2.
To raise an alarm when the output signal is switched to the backup source, select the
Failover
check box in the
Channel
area of the tab for the output you wish to monitor.
Содержание OpenGear DRA-8902 Series
