Ross NK-RP1 Series, Руководство пользователя

Страница: 15 / 28

NK-RP1 Series User Guide (v2.0) Physical Installation • 15
Physical Installation
If you have questions pertaining to the installation of your NK-RP1 Series, please contact us at the numbers listed in
the section “
Contacting Technical Support ” on page 1–10.
Static Discharge
Throughout this chapter, please heed the following cautionary note:
Unpacking the Equipment
On receiving your NK-RP1 Series, check the contents against the packing list. Ensure that all equipment itemized
on the packing list is present and there are no signs of damage before installing the NK-RP1 Series in your system.
If anything is missing or damaged, contact Ross Video immediately to obtain the correct warranty service
procedures.

We recommend that the equipment is installed by qualified and experience personnel, to any relevant standards
and approvals.
Mounting Requirements
The NK-RP1 Series is designed for installation into a standard 19” equipment rack. It has integrated rack ears,
allowing it to be screwed in using standard screws and cage nuts.
The NK-RP1 Series mounts in the rack frame by means of four rack screws fastened through the front and back
mounting ears. This should normally be sufficient to carry the load, including the weight of accompanying cables.
For More Information on...
• the technical specifications for the NK-RP1 Series, refer to the chapter “ Technical Specifications ” on page 5–
25.
Connecting to a Power Source
For redundancy, each power cord should be connected to a separate power source for protection against failure of
the A/C power circuit. In the event of one power supply failure, the panel load is seamlessly transferred to the other
connected redundant power supply.
ESD Susceptibility
— Static discharge can cause serious damage to sensitive semiconductor
devices. Avoid handling circuit boards in high static environments such as carpeted areas and when
synthetic fiber clothing is worn. Always exercise proper grounding precautions when working on circuit
boards and related equipment.