Ross NK RCP-NKM, Руководство пользователя

Страница: 47 / 56

RCP-NKM User Guide (v3.0) Operating the RCP-NKM • 5–5
To lock the RCP-NKM using a panel lock key
1. Press the panel lock key.
The panel lock key illuminates. A brief KEY LOCK message is shown on the screen.
Every key on the RCP-NKM becomes inactive, except for the panel lock key.
2. If you want to unlock the RCP-NKM, press the panel lock key.
The panel lock key switches off. A brief KEY UNLOCK message is shown on the screen.
To lock the RCP-NKM using a protect key
1.
Hold the protect key for 3 seconds.
A brief KEY LOCK message is shown on the screen.
If a panel lock key is assigned to the RCP-NKM, this key illuminates.
Every key on the RCP-NKM becomes inactive, except for the protect key, and panel lock key, if assigned.
2.
If you want to unlock the RCP-NKM, hold the protect key or press the panel lock key, if assigned.
A brief KEY UNLOCK message is shown on the screen.

The protect key does not illuminate.
Protecting a Destination
You can use a protect key to prevent switching of critical crosspoints by others. The protect function ensures that
the selected destination can only receive the selected source across the selected levels. Once protected, the selected
levels on a destination cannot be switched by other remote control panels (or by the same remote control panel if
Block All Panels is selected). The source is not protected, and can be freely routed to other destinations if required.
You can protect any number of destinations.
You can set the extent of protection that is used, that is, protected against other remote control panels or protected
against all remote control panels, via the DashBoard (see “
Assigning a Protect Key ” on page 4–14).
To protect a destination
1.
Make the switch.
2.
Press the protect key.
The protect key and the protected crosspoint are illuminated. The screen indicates that a protect is in place by
showing the protection indicator at the bottom left of the screen.

If you are protecting a destination on a level for which a routing switcher does not respond, a protect breakaway
error (*PROT BRKWY ERR*) occurs.
To remove the protection from a destination
1. Press the key for the protected destination.
2. Press the protect key.
The protection indicator is removed from the screen.