Ross nielsen NWE-IP, Руководство пользователя, Страница: 46 / 80

46 • Enabling the Watermark Encoders NWE-IP User Guide (v5.0)
Configuring the Global Encoder Settings
There are two settings that impact all Watermark Encoder channels on the NWE-IP: Code Type and Time Zone.
These settings are located on the Device Setup tab in the Nielsen Watermark Encoder interface.
To configure the global settings for all watermark encoders
1. Display the Nielsen Watermark Encoder interface in DashBoard as outlined in “ To display the NWE-IP
interfaces in DashBoard ” on page 29.
2. Select the Device Setup tab.
3. Set the audio code scheme for your NWE-IP by selecting an option in the Code Type area. This affects NAES
2 code production only. Choose from the following:
•
Final Distributor — Select this option if the NWE-IP is installed in the station or cable network slot of the
program-distribution chain.
• Program Content — Select this option if the NWE-IP is installed in the broadcast network or syndicate slot
of the program-distribution chain
.
4. Use the Time Zone menu to specify the time zone that your facility is located in.
Configuring a Watermark Encoder Channel
Each row in the Watermark Table tab represents an encoder channel. You can enable up to four encoder channels.
For More Information on...
• AES67 Receiver streams, refer to the chapter “ Configuring the AES67 Receiver ” on page 39.
• AES67 Sender streams, refer to the chapter “ Configuring the AES67 Senders ” on page 49.
To configure a watermark encoder channel
1. Display the Nielsen Watermark Encoder interface in DashBoard as outlined in “ To display the NWE-IP
interfaces in DashBoard ” on page 29.
2. Select the Watermark Table tab.