Hold
Allows you to place a command in a custom control
that will stop the custom control at the hold event.
You must press the custom control button again, or
use a GPI trigger, to continue the custom control.
Pause
Allows you to place a command in a custom control
that will stop a custom control at the pause event. The
length of the pause is set when the pause is inserted.
When holding the
INSERT
button, pauses are shown
as
Px
, where
x
is the length of the pause in frames.
Loop
Allows you to have a custom control run continuously
until stopped, or a Cancel/Cancel All custom control
command is executed from another custom control.
GPO
Allows you to trigger a pre-selected GPI output using
a custom control. The specific GPI output is set when
the GPO command is inserted.
CutKey
Allows you create a custom control that will cut keys
on or off. The specific key and whether the key is cut
on or off is set when the key cut command is inserted.
TrnKey
Allows you to create a custom control that will
transition keys on or off. The specific key and whether
the key is transitioned on or off is set when the key
transition command is inserted.
IncKey
Allows you to create a custom control that will
include a key with the next transition to take the key
on-air, or off-air. The specific key and whether it
should go on-air, or off-air is set when the include
key command is inserted.
Resume
Allows you to resume a particular custom control that
is at a hold. The specific custom control is set when
the resume is inserted. If the target custom control is
not at a hold event, the resume command will not start
the target custom control.
Cancel
Allows you to stop a particular custom control. The
specific custom control is set when the cancel is
inserted.
CancelAll
Allows you to stop all running custom controls.
State
Allows you to embed the entire state of the switcher
into a custom control. A state in a custom control
behaves just like a memory.
To Insert a Special Event into a Custom Control
A special function can be inserted into any existing
custom control, or used when creating a new custom
control.
1.
Start recording or editing your custom control
where you want to insert the special event.
2.
Press
INSERT
.
3.
Use the
INSERT
knob to select the event you
want to insert.
You can also press and hold the
INSERT
button
and press the source button on the custom control
bus for the event you want to insert. The event
names are shown on the mnemonics.
•
Hold
— press the
Insert
knob to insert a
hold event
•
Pause
— use the
Secs
and
Frames
knobs
to enter the length of the pause event
•
Loop
— press the
Loop
knob to loop the
custom control back to the beginning
•
GPO
— use the
Pin
knob to select the GPI
output
•
CutKey
— use the
Key
knob to select the
key, and the
State
knob to select whether
you want the key cut on or off
•
TrnKey
— use the
Key
knob to select the
key, and the
State
knob to select whether
you want the key transitioned on or off
•
IncKey
— use the
Key
knob to select the
key, and the
State
knob to select whether
the key should be transitioned on-air or
off-air with the next transition
•
Resume
— use the
Bank
knob to select the
custom control bank, and the
CC
knob to
select which custom control to resume
56
• Custom Controls — Carbonite Operation Manual (v10.1)
