Switcher Sets
The switcher stores configuration and operation data in
a number of registers that contain the individual entries
for items such as memories or personality settings. These
registers can be stored as a single archive file, or as a
register set that contains all the individual register of that
type; all memories for example. These files are stored
into Sets on USB drive. Different Sets can be created for
different shows or applications, allowing you to quickly
locate and recall the switcher configurations.
The switcher stores information in the following registers:
•
Memory
— contains all the memories for ME,
MiniME
™
, and MultiScreen.
•
Custom Control
— contains all the custom control
banks and macros.
•
Personality
— contains all the user interface settings,
such as transition rates, that are stored under the
PERS
menu. Some personality settings are specific
to the control panel and can be stored independently
if you are working with a MultiPanel system.
•
Installation
— contains all the external device setup,
and software settings for the switcher.
To Store a Set
Switcher Sets can only be stored to a USB drive. The
USB drive must be present before you try to store the
Set. A total of 10 Sets of switcher setup information can
be stored onto the same USB drive.
1.
Insert a USB drive into the USB Port on the frame
or control panel. You must wait 5 seconds for the
switcher to recognise the USB drive.
2.
Press
MENU
>
SAVE
.
3.
Press
Frame-USB
or
Panel-USB
to save the set
file to the USB drive installed into the frame or
control panel.
4.
Use the
All
knob to select the set (
0-9
) you want to
store the switcher registers to.
5.
Press the knob to select the registers you want to
store to the selected set. If an (*) is shown on the
menu, that register already exist in the set and will
be overwritten.
•
All
— store all registers to the set.
•
Mems
— store only the memory registers to the
set.
•
Cust
— store only the custom control registers
to the set.
•
Inst
— store only the installation registers to the
set.
•
PersX
— store only the personality registers to
the set. Use the
Pers
knob to select whether to
include the personality setting for all panels
(
PersA
) or only the current panel (
PersM/1/2
).
6.
Press
Confrm
.
To Load a Set
Switcher Sets can only be loaded from a USB drive. The
USB drive must be present before you try to load the
settings.
1.
Insert your USB drive into the USB Port on the
frame or control panel. You must wait 5 seconds for
the switcher to recognise the USB drive.
2.
Press
MENU
>
LOAD
.
3.
Press
Frame-USB
or
Panel-USB
to load the set
file from the USB drive installed into the frame or
control panel.
4.
Use the
All
knob to select the set (
0-9
) you want to
load the switcher registers from.
5.
Press the selected set. Only registers with an (*)
shown on the menu exist in the set.
•
All
— recall all registers from the set.
•
Mems
— recall only the memory registers from
the set.
•
Cust
— recall only the custom control registers
from the set.
•
Inst
— recall only the installation registers from
the set.
•
Pers
— recall only the personality registers from
the set. Use the
Pers
knob to select whether to
include the personality setting for all panels
(
PersA
) or only a specific panel (
PersM/1/2
).
6.
Press
Confrm
.
Carbonite Operation Manual (v13.0) — Switcher Sets •
53