RORYCO Crowdbeamer, Руководство по эксплуатации устройства

Страница: 21 / 32

4 Crowdbeamer for the presenter
Figure 10: Connecting to a smartphone/tablet using VGA
4. Switch crowdbeamer ON, using the power button.
5. The display will show that the device is "streaming" and the type of input connection.
6. You can now:
- Optionally connect crowdbeamer to a room display (page 22).
- Invite your audience to start sharing your screen.
Connecting to a digital camera
Note: crowdbeamer currently only supports RGB input progressive. Neither YCbCr nor
interlaced input are currently supported.
To connect a digital camera you can use either an HDMI or a VGA connection. HDMI is recommended
since it provides a higher resolution.
1. Make sure that you are looking at the input side of the crowdbeamer device. (See Figure 6: Position
of the input connections (page 19).)
2. Connect the cable to the appropriate connection on the crowdbeamer device: HDMI-in or VGA-in.
3. Connect the adaptor cable between the HDMI/VGA cable and the camera.
Note: The maximum length of the input cable is 10m.
crowdbeamer device manual Version 1.2
©
RORYCO NV Published 2017-07-15 21