3 The crowdbeamer device
Side connections
SD Card slot
(This feature is not supported in the current version.)
Reset button
The Reset button can be used in two ways.
Reset
If the device stops responding to input, press the reset button with a sharp tool. This will reset
all processing units within the device, retaining all configuration parameters.
You can re-start the device normally by pressing the Power button.
Recovery mode
1.
Press and hold the reset button and the main power button at the same time.
2.
Release the reset button.
3.
Wait 2 seconds and release the main power button.
4.
Press the main power button once to boot the device into recovery mode.
In recovery mode
- the configuration parameters can be reset via the web interface,
- firmware can be updated to recover from a non-working state
Note:
(page 29) which resets all the configuration
parameters to their initial factory setting.
Bottom
The crowdbeamer device is free standing but can be mounted in different ways:
• on a tripod, using a 1/4-20UNC connection,
• on a wall using the 2 mounting holes.
(page 32). This template can also be found at
www.crowdbeamer.tech/manual/wall-mounting-crowdbeamer/
Note:
If the device is mounted in an inaccessible position it may be useful to set the
(page 31) option on the configuration system page.
12
crowdbeamer device manual
Version 1.2
©
RORYCO NV Last updated 2017-08-26
Содержание Crowdbeamer
Страница 1: ...device manual Firmware version v2017 08 25...