Page | 7
TF 200.01.0040_ENG
4.1
Recharging procedure
a) Unplug the battery from the docking bay.
b) Plug the charger into the battery. Check to see if the LEDs are on.
If the next LED starts to flash, the battery is recharging. If all the LEDs are on, but turn off after 3
seconds, the charger is incompatible.
c) Wait 8-10 hours until all the 4 LEDs are on without flashing. The battery will sound the buzzer for 3
seconds when it is fully charged. If you have any doubts whether the battery is fully charged, and 4
LEDs are on, unplug the charger. The battery must not charge for more than 10 hours at a time.
d) Unplug the charger.
4.2
Connection procedure
After the battery has been removed from the docking bay, it is important to follow the correct procedure for
reconnecting the battery to the system, as otherwise, the system might not activate.
a) Make sure that all the cables are connected, and that the safety-strip
hasn’t been activated.
b) Plug the battery into the docking bay.
c) Press the battery status button to activate the battery, and thereby the system.
5.
Mounting instructions
4
1
2
3
