background image

DC14025 - UNIVERSAL 

WASHSTAND

Chrome Universal Washstand

FITTING INSTRUCTIONS

Please make sure your basin’s width and depth does not exceed 1000 X 500mm.
Maximum height of legs are 860mm.
Please make sure the warnings and after-care instructions are made available for 
the end user to read.

Position the basin such that the main surface is 860mm from the floor.

Ensure the basin is firmly secured to the wall using appropriate basin fixings before 
proceeding with the installation of the Washstand, 
fix the basin in accordance with the manufacturers instructions.

COMPONENT LIST

x8 Screws
M4 x 26mm

x8 Wall / Floor Plugs
M5 x 27mm

FITTING GUIDE

x2 Legs 

x2 Side Bars

x2 Wall Fixing Brackets

x2 Wall Fixing Bracket
     Covers

x2 Floor Fixing Brackets

x2 Floor Fixing Bracket
     Covers

x1 Front Bar

ADJUSTING YOUR WASHSTAND PRIOR TO FIXING

860mm Max

860mm 

Recommended

500mm Max

1000mm Max

x 1 Hex Key 2mm

1

2

Xmm

Measure Distance Xmm

CUTTING THE LEGS

Only follow this section if you want to lower the height of the legs.

3

Xmm

Cut distance X from the 

base

 

of the leg.

Cut the same distance on both legs.

Base Of Leg

CUTTING THE SIDE BARS

1

Only follow this section if you want to shorten the depth of the Side Bars.

Loosely assemble one Side Bar onto a 
leg joint.

2

Ymm

Measure from the position you 
want your leg to be located, to the 
centre of the current leg position.

Ymm

3

CUTTING THE FRONT BAR

Only follow this section if you want to shorten the width of the front bar.

1

Zmm

900mm

Loosely assemble the front bar 
into the leg joints.

Align the washstand centrally.

Measure a suitable width for your 
washstand (Zmm).

Measure the distance between
leg centres this should be 900mm 
+/- 5mm

Subtract Zmm from 900mm

900mm -Zmm = 

Measurement 

Σ

 

Please read completely before starting.

The Legs, Side Bars and Front Bar can all be cut down to suit the basin you are installing.
Use a metal pipe cutter with an adjustable cutting diameter. To accommodate Ø28 + 
Ø26mm tube.

Slide the knuckle joint onto the leg 
and fix the grub screws using the 
provided hex key to secure it.
Loosely locate the floor 
fixing brackets and covers 
onto the legs.

The leg has an adjustable 
component that makes contact 
with the underside of the basin.
This can be extended up 26mm if 
necessary.

x2 Knuckle Joints - with 
pre assembled Grub 
Screws

Remove the side bar from the joint and cut distance Y on both bars.

IMPORTANT - Do not cut the end with the flange. Only cut the plain end.

Отзывы: