ROPA KS 475, Перевод оригинального руководства по эксплуатации

Страница: 78 / 110

Maintenance and service
Angular gear
7.1 Angular gear
The angular gear is located at the top centre of the machine and transmits the PTO
shaft power of the tractor via a cardan shaft further to the topper drive.
The illustration shows KS 475
(1) Oil filling screw with venting
(2) Oil drain screw in the centre below the gear
Check the angular gear for leaks before switching on the tractor PTO shaft every day.
If any perspiration appears on the angular gear, call a service technician.
The first oil change is required after 50 operating hours, further oil changes must be
performed annually.
When changing, oil proceed as follows:
– before changing oil, clean a wide area around the angular gear;
– change oil only with gears warm after operation. Dismantle the gear unit from the
machine if necessary. To do this, dismantle both cardan shafts and loosen four
screws above the gear;
– put an oil-resistant collecting vessel of sufficient size underneath;
– open the oil drain plug ( 2 ) and the oil filling screw ( 1 ), let the gear oil flow out;
– reinsert the oil drain screw ( 2 );
– pour some fresh oil into the filler opening;
– screw on the oil filling screw ( 1 ) again;
– conduct a test run and then check the angular gear for leaks.
Prescribed oil types: Gear oil API GL 5, SAE 90
Filling volume KS 475:
approx. 1.2 litres
Filling volume KS 490: approx. 1.7 litres
78 / 110