Preparing for Use
R&S
®
NRX
13
Getting Started 1424.7070.02 ─ 05
Develop and implement an efficient ventilation concept.
4.6
Connecting to the AC Power Supply
The R&S NRX can be used with different AC power voltages and adapts itself
automatically to them. Adjusting the R&S NRX to a particular AC supply voltage is
therefore not required. Refer to the data sheet for the requirements of voltage and
frequency.
The power switch can be set to two positions:
●
[0]: The instrument is disconnected from the mains.
●
[I]: The instrument is power-supplied. It is either ready for operation
(STANDBY) or in operating mode.
1. Plug the AC power cable into the AC power connector on the rear panel of the
R&S NRX. Only use the power cable delivered with the R&S NRX.
2. Plug the AC power cable into a power outlet with ground contact. The R&S
NRX complies with safety class EN61010-1.
The required ratings are listed next to the AC connector and in the data sheet.
Further information:
●
Chapter 5.2.5, "AC Supply and Power Switch"
4.7
Switching On or Off
The possible instrument states are described in
Chapter 5.1.6, "On/Standby Key"
To switch on the R&S NRX
1. To turn on the power, press the AC power switch at the rear to position [I]
(On).
After power-up, the R&S NRX is in standby or ready state, depending on the
position of the on/standby key.
2. If the R&S NRX is in standby state, press the on/standby key.
Switching On or Off
