Ronde & Schwarz 1304.0004K03, Руководство пользователя

Страница: 774 / 1071

Remote Commands
R&S
®
FPL1000
774 User Manual 1178.3370.02 ─ 11
Parameters:
<TriggerLevel> For details on available trigger levels and trigger bandwidths see
the data sheet.
*RST:
-20 dBm
Default unit: DBM
Example: TRIG:LEV:IFP -30DBM
Manual operation: See "Trigger Level" on page 341
TRIGger[:SEQuence]:LEVel:IQPower <TriggerLevel>
This command defines the magnitude the I/Q data must exceed to cause a trigger
event.
Note that any RF attenuation or preamplification is considered when the trigger level is
analyzed. If defined, a reference level offset is also considered.
Parameters:
<TriggerLevel> Range: -130 dBm to 30 dBm
*RST: -20 dBm
Default unit: DBM
Example:
TRIG:LEV:IQP -30DBM
Manual operation: See "Trigger Level" on page 341
TRIGger[:SEQuence]:SLOPe <Type>
For all trigger sources except time you can define whether triggering occurs when the
signal rises to the trigger level or falls down to it.
Parameters:
<Type> POSitive | NEGative
POSitive
Triggers when the signal rises to the trigger level (rising edge).
NEGative
Triggers when the signal drops to the trigger level (falling edge).
*RST:
POSitive
Example: TRIG:SLOP NEG
Manual operation: See "Slope" on page 342
TRIGger[:SEQuence]:SOURce <Source>
This command selects the trigger source.
For details on trigger sources see "Trigger Source" on page 339.
Note on external triggers:
Setting Basic Spectrum RF Measurement Parameters