Ronde & Schwarz 1304.0004K03, Руководство пользователя

Страница: 38 / 1071

Getting Started
R&S
®
FPL1000
38 User Manual 1178.3370.02 ─ 11
The meanings of the labels on the R&S FPL1000 are described in Chapter 1.2, "Labels
on R&S FPL1000" , on page 10.
4.2.2.1 AC Power Supply Connection and Main Power Switch
An AC power supply connector and main power switch are located in a unit on the rear
panel of the instrument.
Main power switch function:
Position 1: The instrument is in operation.
Position O: The entire instrument is disconnected from the AC power supply.
For details, refer to "Connecting to power" on page 8 and Chapter 4.1.5, "Connecting
to Power" , on page 19.
4.2.2.2 Li-Ion Battery Packs and DC Power Connector
With the Li-ion battery pack (option R&S FPL1-B31), the R&S FPL1000 can be oper-
ated independently of an AC or DC power supply. The instrument can house 2 Li-ion
batteries which can be charged both via AC or DC power supply.
For safety information concerning batteries, see "Handling batteries safely" on page 9.
As an alternative, a DC power supply connector (option R&S FPL1-B30) is available.
DC power supplies from +12 V to +24 V and from 13 A to 6.5 A can be used. Connect
the connector according to the following diagram:
Pin Description
1 2
3
1 Plus
2 Ground
3 Not used
If you use an external power supply unit to supply safety extra-low DC voltage (SELV)
to the instrument, be sure to meet the requirements for reinforced/double insulation in
accordance with DIN/EN/IEC 61010 (UL 3111, CSA C22.2 No. 1010.1) or DIN/EN/IEC
60950 (UL 1950, CSA C22.2 No. 950). Provide current limitation in accordance with
DIN EN 61010-1 Appendix F2.1.
Also see "Connecting to power" on page 8.
4.2.2.3 GPIB Interface
The optional GPIB interface (R&S FPL1-B10) is in compliance with IEEE488 and
SCPI. A computer for remote control can be connected via this interface. To set up the
connection, a shielded cable is recommended.
Instrument Tour