Copyright ROMPA® Ltd
SPIN N STARE 18297, KH 7.04
SPIN ‘N’ STARE 18297
CONTENTS
1
x
reversible circular panel
1
x
mounting kit: wood block with central screw
B
, black ball
A
, 4 x 80mm screws, 4 x
50mm
wall
plugs
BEFORE USE
Wall mount this product checking:
•
the construction of your wall – is it capable of holding the weight of this product, bearing in
mind that users will be turning it
•
the suitability of the mounting kit provided
Remove (unscrew) the black ball
A
from the central screw
B
of the wood block if it is attached.
Using the four pre-drilled holes
C
(one in each corner) in the wood block, mark the wall where the
block will be attached. Drill corresponding holes in your wall. Fit the wall plugs into the holes you
have drilled. Screw the screws through the wood block and into the wall plugs.
Pass the centre of the reversible circular panel onto the screw in the centre of the wood block. Screw
the black ball onto the central screw of the wood block to hold the panel in place. Tighten.
USE
1. Spin the circular panel to achieve different optical effects. Different speeds will obtain different
effects.
2. To change the effect, remove the black ball; remove the panel; turn the panel over and replace
the black ball. Check the ball is secure before allowing users to resume play with the panel.
SAFETY
Always supervise the use of this product.
CARE & MAINTENANCE
Clean using a slightly damp soft cloth. Do not immerse in water or use abrasive cleaning products.
SPECIFICATION
Weight: 3.5kg
Size: 63cm diameter
