Warranty Pass
Made in Germany
D1940
2
Corner Entry
323-4
(please retain and file together with the purchase receipt)
Dear Customer,
Thank you for purchasing this product. We would like to ask you to observe the following notes and tips so you
can enjoy this product for a long time.
Checking the product:
Lay out the parts prior to installation and check that all component parts are present. At the same time check for
any damage that may have occurred during transportation. No claim for defective product will be accepted after
the product has been installed.
Important: The toughened safety glass used may, from time to time, show characteristic features due to its manu-
facturing process (EN 12150). So-called hair scratches can occur on the glass plate’s surface up to a length of
150mm, as well as blisters in the glass up to a diameter of 0.75 mm. In either case there are no grounds for com-
plaint. The accepted inspection distance is 1.5 metres under normal lighting conditions. The same applies to the
surface of the powder-coated profiles. Likewise please take into account that we use different, high quality
materials when manufacturing the shower enclosure, which in exceptional cases can lead to slight colour differ-
ences. These unfortunately do not warrant a complaint.
A waterproof and leak tight fit is not achievable with frameless shower cubicles due to their construction.
Assembly/ Sealing:
It is imperative to carry out the assembly according to the instructions which follow. This will guarantee flawless
product performance. If you have reason to complain, despite careful assembly in accordance with the
instructions or if you require technical advice, our service department for shower information can offer you
assistance. Cover up the work area with blankets in order to avoid damages to the shower tray or to the tiles.
Please ensure that you seal
horizontal
joints
only from
the outside.
Please seal the perpendicular joints on the outside from top to bottom. In the event of an recurring
leak please make sure that you followed the instructions exactly.
Spare parts:
Any missing components, those damaged during transportation, or parts worn out over time can be ordered via
the service department. Please place the order in writing using our attached spare parts list together with the
Warranty Pass. The parts ordered will be sent direct to the original distributor. Any parts ordered as a matter of
wear and tear will be charged for. You acknowledge your consent with your signature.
Cleaning/ Maintenance:
Silicone sealing materials are not resistant to mildew over time. We recommend airing your bathroom after
showering and cleaning the shower cubicle regularly. For cleaning we recommend normal liquid detergents for the
bathroom or a small solution of Milton, diluted appropriately with water. Clean with a soft cloth or a sponge.
Please do not use cleaning powder or solvents.
Once again, thank you for purchasing this product .
If you have any improvements or suggestions then please feel free to write to us.
Your Shower-Team
From time to time it will be necessary to treat moving parts (such as hinges, rollers etc.) with Vaseline.
Take the opportunity to re-adjust and tighten any screws etc..
Cleaning agents with a pH value of under 3 or over 10 can cause damages on profiles, hinges, handles and glass
not c er
surfaces and material are
ov ed by our manufacturer's warranty.
coating. These agents may not be used for cleaning. Damages caused by inappropriate handling or cleaning on
Important information to ensure a leak tight finish.
