49
Flywheel:
The wheel can be taken off the mono fork by removing the screw in the centre hole of the rim.
Use a 5 mm hex head wrench (Allen key) to do this.
Then remove the outer bolts holding the rim halves together and pull the rim halves apart.
Remove the tube from the tyre and apply a patch or replace it with a new one.
Use a 5 mm hex head wrench (Allen key) to do this.
Figure 11
Drive wheel:
❗
Before separating the rim, force the air out of the tube by squeezing the valve.
First screw off the 4 hex bolts around the centre hole (the screws to the right) of the hub. Use a
6 mm hex head wrench (Allen key) for this.
✋
Do not loosen the large bolt in the centre.
Remove the outer bolts on the left of the loose wheel and pull the rim halves apart.
Remove the tube from the tyre and apply a patch or replace it with a new one.
Figure 12
Содержание BOA2
Страница 61: ...61 ...
Страница 62: ...MANUAL MANUAL 62 ...
Страница 63: ...63 ...
Страница 64: ...ROLTEC el kørestole A S Lægårdsvej 13 DK 8520 Lystrup Telephone 45 87 43 49 00 Fax 45 87 43 49 29 ...
