Roltec BOA2, Руководство пользователя

Страница: 48 / 64

MANUAL MANUAL
48
Figure 5 Open chair to battery room
Access to the batteries
To gain access to the batteries, remove the 4 screws holding the front plate.
The 2*2 screws located in the battery holders should also be removed.
Figure 6 Battery front plate
Batteries:
Batteries: The batteries should be replaced by the dealer. The dealer will ensure that the
batteries are disposed of in the most environmentally-friendly manner. If the batteries are
damaged and leak, contact your dealer, as it may be hazardous to come into contact with the
contents of the batteries.
See label for wiring diagram.
⚠
Avoid touching leaking batteries, as the contents can be harmful to your health. It is
important to place the chair outside or in a very well-ventilated room.
Tyres:
To ensure the wheelchair works properly, it is important that the tyres have the prescribed
pressure. The maximum pressure is stated on the tyre.
The inner tubes in the tyres are equipped with auto-valves. They can therefore be pumped with
an automatic pump.
ROLTEC recommends air pressure in the large tyres of: 40 PSI.
❗
Check the air pressure at least once a month. Power consumption increases significantly if
there is not enough air in the tyres. Different pressure in the tyres will result in uneven running.
The wheelchair can be supplied with anti-leak tyres as an extra, or an anti-leak liner on both
front and rear wheels.