Rolls-Royce Helicon X3, Руководство пользователя

Страница: 60 / 140

Operating Instructions
Page 8 of 22 Doc. No.: 13S000411
Revision: A
Copyright © 2010 Rolls-Royce plc
3 Standard Operations
In this section all available control functions and buttons available in the Helicon X3
user interface is described.
Note: Depending on thruster type and configuration, all functions and buttons
may not be applicable for your installation, or somehow differ from what
is presented here.
3.1 Port/Stbd Main Propulsion
The Port/Stbd Main propulsion page contains all information and functions available for
Main Propulsion systems/thrusters.
3.2 Bow/Stern Tunnel Thruster
The Bow/Stern Tunnel Thruster pages contain all information and functions available
for the tunnel thruster.
3.3 In Command
To operate the lever or activate a function it is necessary to first be In Command .
It is not possible to transfer the control to an unmanned manoeuvre station.
This is how you change responsibility between bridge stations:
1.
Set the control levers at the new station in accordance to the position of the levers
at the present station in command.
2. Press the In Command button.
3. To confirm press the Accept button within 10 seconds when it starts to flash.
4. The command is transferred when the In Command button turns blue.
Note: There is normally no command transfer interlock because of discrepancy
between the lever position at the present station in command and the lever
position at the new station to be in command.