Roline UD.6L0202D1275A02, Руководство пользователя

Страница: 175 / 176

User M anual of Network Video Recorder
175
If the resource is not enough, please end some unnecessary p rocesses.
4. Check whether the fault is solved by the above steps.
If it is solved, finish the process.
If not, please contact the engineer from our manufacturer to do the further process.

When using the NVR to get the live view audio, there is no sound or there is too much noise, or t he
volume is too low.
Possible Reasons:
a) Cable between the pickup and IP camera is not connected well; impedance mismatches or incompatible.
b) The stream type is not set as “Video & Audio”.
c) The encoding standard is not supported with NVR.
Steps:
1. Verify the cable between the pickup and IP camera is connected well; impedance matches and compatible.
Log in the IP camera directly, and turn the audio on, check if the sound is normal. If not, please contact the
manufacturer of the IP camera.
2. Verify the setting parameters are correct.
Select “M enu > Record > Parameters > Record”, and set the Stream Type as “Audio & Video”.
3. Verify the audio encoding standard of the IP camera is supported by the NVR.
NVR supports G722.1 and G711 standards, and if the encoding parameter of the input audio is not one of
the previous two standards, you can log in the IP camera to configure it to the supported standard.
4. Check whether the fault is solved by the above steps.
If it is solved, finish the process.
If not, please contact the engineer from our manufacturer to do the further process.

The image gets stuck when NVR is playing back by single or multi -channel.
Possible Reasons:
a) Poor network between NVR and IP camera, and there exists packet loss during the transmission.
b) The motion detection and alarm functions are enabled, and the parameters of M ain Stream (Normal) and
M ain Stream (Event) are different. So the image looks stuck due to the image changes between different
resolutions.
c) The frame rate is not the real-time frame rate.
d) The NVR supports up to 16-channel synchronize playback at the resolution of 4CIF, if you want a
16-channel synchronize playback at the resolution of 720p, the frame extracting may occur, which leads to
a slight stuck.
Steps:
1. Verify the network between NVR and IP camera is connected.
1) When image is stuck, connect the RS-232 ports on PC and the rear panel of NVR with the RS-232
cable.
2) Open the Super Terminal, and execute the command of “ ping 192.168.0.0 –l 1472 –f
”
(the IP address
may change according to the real condition), and check if there exists packet loss.
Simultaneously press the Ctrl and C to exit the ping command.
2. Check the parameters of M ain Stream (Normal) and M ain Stream (Event).
Select “M enu > Record > Parameters > Record”, and set the resolution of M ain Stream (Event) the same as
the one of M ain Stream (Normal).
3. Verify the frame rate is real-time frame rate.
Select “M enu > Record > Parameters > Record”, and set the Frame Rate to “Full Frame”.
4. Verify the hardware can afford the playback.
Reduce the channel number of playback.
Select “M enu > Record > Parameters > Record”, and set the resolution and bitrate to a lower level.