Roland VersaStudio BT-12, Руководство по эксплуатации

Страница: 66 / 234

64
2. Preparing for Printing
• Example: Instep
When printing on the instep, widen and load the fabric so that the printable area of the
instep is in the middle.
DYX070
1
1. Printable area
Loading a Sleeve in the Sleeve & Socks Tray
When you want to print on the sleeves of a garment, use the Sleeve & Socks Tray.
• To use Sleeve & Socks Tray, you need to install the latest firmware (ver. 1.20 or later) on
the machine.
• If you perform printing with the edges of the fabric still outside of the table, the fabric or
this machine might be damaged. After fixing the fabric, make sure that it fits within the
width of the tray.
• Do not forcibly lift or twist the table. Doing so may cause a failure
1.
Press the [Power] key, and then turn on the machine.
Detach the tray after turning on the machine. If you detach the tray before turning on the
machine, turn it off first, and then turn it on again.
2.
Make sure that the tray stand is out of the machine, and then detach the tray.
•
If it is not out of the machine, press the [Tray] key to eject the tray.
•
Lift up the tray lightly and pull the tray to detach it.