Roland VersaStudio BT-12, Руководство по эксплуатации

Страница: 124 / 234

5. Machine Setup Menus
122
Using the [System] Menu
You can set basic functions required to use the machine. The machine can be used on factory
default, but the configuration can be changed depending on the condition of the user. The
changed condition holds even if the machine is turned off.
Energy Saver
Use Energy Saver mode to reduce the machine's power consumption.
You can specify how long the machine remains idle before it switches to Energy Saver mode.
When the machine is in Energy Saver mode, it requires time to start up when it receives a
print job.
You can specify between 5 and 60 minutes as the idle time before switching to the Energy
Saver mode.
• 5 minutes
• 15 minutes
• 30 minutes
• 45 minutes
• 60 minutes
Default: [ 5 minutes ]
Notify by Email
You can specify whether or not to send notification that a printer error has occurred to a
particular e‐mail address.
Use the Web browser to specify e‐mail address to send notification. See page 138 "
Notifying
the Machine Status by E‐mail ".
• On
• Off
Default: [ Off ]
Unit of Measure
You can switch the measurement between "mm" and "inch".
• mm
• inch
(mainly Europe, Asia, and China)
Default: [mm]
(mainly North America)
Default: [inch]
Uni‐direct.Prt.
You can configure the machine to eject ink only when the head is moving in a particular
direction.
Normally, the way the ink is ejected depends on the fabric type.
If you select [Always], printing is performed unidirectionally regardless of the fabric type.
By printing unidirectionally, you can eliminate differences in ink ejection timing and so
prevent misregistration when printing thin lines.
If you select [Auto Detect], printing is performed according to the settings of the [Garment
Type:] specified in the printer driver.