Roland VersaCAMM ECO-SOL MAX3, Инструкция по эксплуатации

Страница: 6 / 21

Switching the Ink
6
ECO-SOL MAX 3 Ink Switching Method

Install the drain bottle.

Press .

Remove all the currently inserted ink cartridges.

When the screen on the left is displayed, remove the drain bottle and
discard the discharged fluid.
Use the included drain funnel to transfer the discharged fluid from the printer's drain
bottle to the included drain bottle.

Install the drain bottle.

Press .

Before you insert the new ink cartridge
for each color, gently shake the cartridge.

Set in place new ink cartridges.
When you set in place the new cartridges, the machine starts filling with ink.
When the screen shown in the figure appears, the ink cartridge switching operation
is finished. Proceed to the next procedure.
STEP 3: Cleaning of the Periphery of the Print Heads (Manual Cleaning)
CAUTION
Be sure to perform operations as specified by the instructions, and never touch any
area not specified in the instructions.
Failure to observe these instructions may cause the machine to move suddenly, resulting
in injury.
4'/18'51.%46
'/26;
&4#+0$166.'
5'651.%46
(+..+0)+0-
12'0%18'4.
Important notes on this procedure

Before attempting this operation, remove any media.

To prevent the print heads from drying out, finish this procedure in 30 minutes or less. A warning beep sounds after
30 minutes.

Never use any implements other than the included cleaning sticks. Cotton swabs or other lint-producing items may dam-
age the print heads. If you use up the cleaning sticks, purchase new ones from your authorized Roland DG Corp. dealer.

Do not use a previously used cleaning stick. Reusing cleaning sticks may reduce the printing quality.

Do not put a cleaning stick that has been used for cleaning into the cleaning liquid. Doing so will deteriorate the
cleaning liquid.

Never rub the nozzle surface of the print heads.
 Stroke the sponges very gently, applying as little pressure as possible. Never rub, scrape, or crush them.