Roland VersaCAMM ECO-SOL MAX3, Инструкция по эксплуатации

Страница: 10 / 21

Switching the Ink
10
ECO-SOL MAX 3 Ink Switching Method
STEP 4: Replacing the Wipers and Felt Wipers
CAUTION
Be sure to perform operations as specified by the instructions, and never touch any
area not specified in the instructions.
Failure to observe these instructions may cause the machine to move suddenly, resulting
in injury.
1.
Replace the wipers.

Open the right cover.
Preparations are complete when this screen appears.

Replace the first wiper.

Press .

Close the right cover.
If a warning beep sounds during operation
Attach the left and right covers, close the front cover, and then press . After this, you cannot continue
the operations with the procedures in this manual. Refer to the user's manual of the model that you are using
and perform the operations according to the details listed under
P. 20 "When Operations Are Interrupted"
.
12'0%18'44
4'2.#%'9+2'4
(+0+5*'&!
%.15'%18'44
Place the inclined end on the back side.
If the wiper is installed with the incorrect
orientation, appropriate cleaning will not
be possible.
Hook
Disconnect the hooks.
Using the tweezers to press on the hook in the hole on
the wiper makes it easier to remove the wiper.
Pull up and
out.
Hook
Tweezers (included)
Attaching a new wiper
Removing an old wiper
Attach the part to the hooks.
Be sure to attach the part to the
hooks. Failure to do so may result
in dot drop-out or other problems.
If the area is dark and difficult
to see, use a flashlight or a
similar device to illuminate
the area.