Roland TD-07, Руководство пользователя

Страница: 26 / 30

26
Troubleshooting
Troubles Items to check Action Page
Troubles with sound
No sound /
Insufficient volume
Is the TD-07 correctly connected to the
amplified speaker or headphones?
Connect amplified speakers or headphones to the
TD-07’s OUTPUT/PHONES jack.
p. 6
If you’re connecting an amplified speaker, connect to
the amplified speaker’s input jack.
–
Is the dedicated connection cable correctly
connected to the TRIGGER INPUT connector
located on the bottom of the TD-07?
Check the connections.
“Setup
Guide”
Could an audio cable of headphones or
amplified speaker be broken?
Try using a different cable. –
If sound is not output from the amplified
speaker that’s connected, is sound output
when you connect headphones?
If sound is being output, either the connection
cable of the amplified speaker is broken, or there
is a malfunction in the amplified speaker that’s
connected. Check the connected device and cable.
–
Could the TD-07’s volume be lowered?
Adjust the volume to an appropriate level –
Could the volume of the connected amplified
speaker be lowered?
Could the volume be lowered on the
smartphone etc. that’s connected to the MIX
IN jack or via Bluetooth?
A specific pad does
not sound
Are the cables correctly connected to each
pad and pedal?
Connect the appropriately labeled cable to each pad.
“Setup
Guide”
Could the pad sensitivity be lowered? Adjust the pad sensitivity (Sens).
p. 19
If you expanded the pads or replaced a pad
with a different type of pad, is the pad type
specified correctly?
Adjust the pad type.
No sound when you
press the kick pedal
Is the cable labeled KIK connected to the kick
pad?
Check the connections.
“Setup
Guide”
No sound when you
press the hi-hat pedal
Is the cable labeled HHC connected to the
hi-hat pedal?
The sound of another
pad is also heard
when you strike the
pad.
If multiple pads are attached to the same
stand, the vibration of a strike can be
transmitted to another pad, causing it to
sound inadvertently.
Note the following points, and make changes to the
attached positions.
5
Separate the pads so that they do not touch each
other.
5
Firmly tighten the pad attachment knob when
attaching it to the stand.
In some cases, sound from a monitor speaker might
cause unintended triggering.
5
Set up the pads at a distance from the speakers
5
Angle the pads, placing them where they are less
likely to be affected by the sound
5
Increase the pad’s minimum sensitivity value
(Threshold) (p. 19)
–
Two or more notes
are sounded when
you strike once
Is the pad fastened to the stand?
Fasten the pad firmly to the stand.
Also set the RetrigCancel parameter.
p. 23
Sounds do not play
reliably
Is the snare and tom pad’s mesh head
tensioned evenly?
Adjust the mesh head tension. Use a drum key to
adjust the pad’s tuning bolts. Slightly higher tension
is good for proper triggering.
“Setup
Guide”