Roland monoFabARM-10, Руководство пользователя

Страница: 26 / 53

Output (Printing)
26
Add resin to the liquid material vat
Pour the dedicated resin into the liquid material vat.
1.
Wear rubber gloves (included or commercially available) and protective eyewear (commercially available).
MEMO
Adjust the height of the ARM-10’s legs before use. Adjust the legs so that the resin will collect on the printing platform side (the back of the machine) when the
amount of resin in the liquid material vat gets low. For details, refer to the “Roland DG Start-up page” (http://startup.rolanddg.com/).
2.
Open the lid of the resin bottle, and pour resin into the liquid material vat.
Do not fill with resin beyond the FULL line of
the rear side.
FULL
MEMO
• The amount of resin required for printing can be shown in monoFab Player AM.
• Resin volume of 100 ml is equivalent to approximately 110 g when using a commercially available measuring cup.
3.
Close the lid of the resin bottle securely.
NOTE
If the lid of the resin bottle is not closed securely, the remaining resin may deteriorate or cure, making it impossible to use.