Cutting (One Side Cutting)
89
STEP 2 : Set the Origin Point
About Origin Point
Before you start cutting, you must set the origin point.
When you cut with this machine, you need to set the X, Y, and Z origins.
The X and Y origins are determined by the cutting data and the location of
the material. (
“X”
and
“Y”
cannot be set individually.) You normally align
the Z origin with the surface of the material. Take the size of the material
and the length of the cutting tool into consideration when you set the
origins.
In addition, the locations that you should specify for the origins vary
depending on the application software that you are using. Set up
depending on the specification of the application software that you are
using.
"
SRP Player :
“Origin point of the Model / Origin point”
"
MODELA Player 4 :
“Origin point of the Model / Origin point”
1. Prepare to set the origin point
1.
Select
[Machine Coordinate System]
on the VPanel.
2.
Click
[X/Y][Z]
of
[Origin]
in
[Move]
.
〇●〇〇〇
Содержание monoFab SRM-20
