2
Song Edit
A Setup Mixer screen has been added to Song Edit. This allows you to easily edit the Level, Pan, Key Shift, Reverb, Mute, and BPM of each step.
You must stop the song before you perform song editing operations.
Since the setup parameters you edit for each pattern are stored as song data, the setup data of the original pattern will not change.
If the system
Song Play Mode
is
“MODE2,”
and the same pattern as the currently-playing pattern is played as the next step, the setup
parameters of that step will be ignored.
1.
Select the song that you want to edit.
2.
In Song Mode, press [F2(Song Edit)] to access the Song Edit screen.
fig.songedit01a_50
3.
In the Song Edit screen, press [F5(Setup Mixer)] to access the Setup Mixer screen.
fig.songedit02_50
4.
Use [BWD]
or [FWD]
to select the step whose setup parameters you want to edit.
*
You can’t automatically proceed to the next step while editing a song.
5.
Use the [CURSOR] keys, [VALUE] dial, or [DEC][INC] to edit the setup parameters.
• You can press
[F1(Level)]
,
[F2(Pan)]
,
[F3(Key Shift)]
, or
[F4(Reverb Level)]
and use the Part Mixer sliders to edit the setup parameters. Use
[PART ASSIGN]
to switch the part (1-8/9-16) controlled by the sliders.
• Use
[PART (SELECT/MUTE)]
and part buttons
[1]
–
[16]
to specify the Mute status.
• Press
[F5 (BPM Click)]
to specify the BPM.
For details on each setup parameter, refer to “
About the setup parameters
” (p.26) in the MC-909
Owner’s Manual
.
6.
Save the song.
For details on how to save the song, refer to “
Saving a song
” (p.85) in the MC-909
Owner’s Manual
”.
Setup Mixer
MC909_v12_je.book 2 ページ 2004年10月28日 木曜日 午後2時7分