Roland Juno-Stage, Руководство пользователя

Страница: 80 / 256

80
Chapter 5. Applying Effects to the Sound
In Patch mode you can use one multi-effect (MFX), one chorus, and one reverb.
Here you can make overall settings for effects, such as the output destination and level of the various signals.
fig.Routing
For details on how to make settings, refer to “Making Effect Settings” (p. 79).
Applying Effects in Patch Mode
Signal Flow and Parameters (EFFECT ROUTING)
Parameter Range Explanation
Tone Select
(Rhythm Key Select)
1–4
(A0–C8)
The tone (rhythm tone) to edit
If you’ve selected a rhythm set, this will be Rhythm Key Select.
Tone Output Level 0–127
Level of signal sent from each tone to the destination specified by Output Assign ( )
Tone Chorus Send
Level
0–127 Level of signal sent from each tone to the chorus
Tone Reverb Send
Level
0–127 Level of signal sent from each tone to the reverb
MFX Type 0–79
Type of multi-effect to use (choose one of 79 types)
For details on each multi-effect, refer to “Multi-Effects Parameters (MFX1–3, MFX)” (p. 163).
Patch Output Assign
(Rhythm Output
Assign)
MFX,
L+R,
L,
R,
TONE
Specifies how the unprocessed sound of the patch (rhythm set) will be output
If you’ve selected a rhythm set, this will be Rhythm Output Assign.
MFX: Output in stereo via the multi-effect. Chorus and reverb can also be applied after the multi-
effect.
L+R:
Output in stereo from the OUTPUT jacks without passing through the multi-effect
L: Output in mono from the OUTPUT L jack without passing through the multi-effect
R:
Output in mono from the OUTPUT R jack without passing through the multi-effect
TONE: Output according to the settings of each tone
Tone OUTPUT
Assign
MFX,
L+R,
L,
R
Specifies how the unprocessed sound of each tone will be output
MFX:
Output in stereo via the multi-effect. Chorus and reverb can also be applied after the multi-
effect.
L+R: Output in stereo from the OUTPUT jacks without passing through the multi-effect
L:
Output in mono from the OUTPUT L jack without passing through the multi-effect
R: Output in mono from the OUTPUT R jack without passing through the multi-effect
* The setting you specify here is valid only if Patch Output Assign is set to “TONE.”
* If Structure (p. 99) is set to TYPE 02–10, the settings for tone 1 (3) will follow the settings of tone
2 (4). (This is because the outputs of tones 1 and 2 are combined into tone 2, and the outputs of
tones 3 and 4 are combined into tone 4.)
MFX Output Level 0–127 Volume of the sound that has been processed by the multi-effect
MFX Chorus Send
Level
0–127 Amount of chorus applied to the sound that has been processed by the multi-effect
MFX Reverb Send
Level
0–127 Amount of reverb applied to the sound that has been processed by the multi-effect
Chorus Type 0–3
Type of chorus
0 (OFF):
Chorus/delay will not be used
1 (CHORUS): Chorus
2 (DELAY):
Delay
3 (GM2 CHO): GM2 chorus
1 2
3
4
5
6
7
8
9
10
11
12
13
1
2 6
3
4
5
6
7
8
9
10
JUNO-STAGE_e.book 80 ページ ２００８年１０月１７日 金曜日 午後１２時２７分