
34
System Settings
MIDI
Parameter
Value/Explanation
Local Switch
Determines whether the internal sound generator is disconnected (OFF)
from the controller section (keyboard, pitch bend/modulation lever,
buttons, sliders, pedal, and so on); or not disconnected (ON). Normally
you’ll leave this “ON.” Choose the “OFF” setting if you want operations on
the JUNO-DS to only control DAW software on your computer.
OFF, ON
Patch Rx/Tx Ch
In patch mode, specifies the MIDI message transmit/receive channel for
the keyboard part.
1–16
Performance
Control Channel
Specifies the MIDI receive channel on which MIDI messages (program
change/bank select) from an external MIDI device will be received by the
JUNO-DS to switch performances. Choose “OFF” setting if you don’t want
performances to be switched from a connected MIDI device.
1–16, OFF
Transmit
Program Change,
Bank Select, Active
Sensing
Specifies whether program change messages/bank select messages/active
sensing messages will be transmitted (ON) or not be transmitted (OFF).
OFF, ON
Transmit
Edit Data
Specifies whether changes you make in the settings of a patch or
performance will be transmitted as system exclusive messages (ON), or will
not be transmitted (OFF).
OFF, ON
Receive
Program Change,
Bank Select
Specifies whether program change messages/bank select messages will
be received (ON) or not be received (OFF).
OFF, ON
Soft Through
If this is “ON,” incoming MIDI messages from the MIDI IN connector will be
re-transmitted without change from the MIDI OUT connector.
OFF, ON
USB Driver
Sets the USB driver.
*
This setting will take effect when you turn the power off, then on again.
GENERIC
Choose this if you want to use the generic USB driver
provided by your computer’s operating system.
VENDOR
Choose this if you want to use a USB driver
downloaded from the Roland website. (*1)
*1: Download the Driver
In order to use the JUNO-DS with the “VENDOR” setting, you must download the driver
from the following URL and install it on your computer.
For details on installation, refer to the following URL.
&
http://www .roland .com/support/
CONTROL
Parameter
Value/Explanation
Sys Ctrl 1–4
Source
Specify the MIDI messages that will be used as system controls.
System Control settings allow you to specify MIDI messages that will
apply in common to the entire JUNO-DS, and can be used for controlling
volume, tone, etc.
You can assign up to four MIDI messages for this type of control.
*
If you want to make assignments for realtime control of the sound and
effects for each tone independently, use “Matrix control” (p. 12) or
“MFX control” (p. 18).
OFF
No function is assigned.
CC01–31, 32 (OFF),
33–95
Controller number 1–31, 32, 33–95
PITCH BEND
The same effect as moving the pitch bend.
AFTERTOUCH
Aftertouch
INFORMATION
Parameter
Value/Explanation
Version
View the software version.
Expansion
Displays information about expansion sounds.