Roland JUNO-Di Editor, Руководство пользователя

Страница: 42 / 92

42
Detailed Editing for a Patch (PATCH Parameters)
You can use the note number to control the way each Tone is played.
fig.TMT-K.e
The function which allows you use MIDI messages to make changes in realtime to the tone parameters is called the Matrix Control . Up to four Matrix
Controls can be used in a single patch.
To use the Matrix Control, specify which MIDI message (SOURCE) will be used to control which parameter (DESTINATION), and how greatly
(SENS), and the tone to which the effect is applied (TONE).
VELOCITY and KEYFOLLOW correspond to Note messages.
• Although there are no MIDI messages for LFO 1 through TVA Envelope, they can be used as Matrix Control. In this case, you can change the
tone settings in realtime by playing patches.
• If you want to use common controllers for the entire JUNO-Di, select “SYS-CTRL1”–”SYS-CTRL4.” MIDI messages used as SYS-CTRL 1–4 are set
with the SYSTEM CTRL SRC 1–4 parameters (p. 14).
• If RCV BENDER, RCV EXP, or RCV HOLD-1 (p. 43) are “ON,” incoming MIDI messages of these types will affect the Pitch Bend, Expression, or
Hold 1 settings at the same time that they affect the target parameter (DESTINATION). If you want these incoming messages to affect only the
target parameter, turn these settings “OFF.”
• There are parameters that let you specify whether specific MIDI messages will be received for each channel in a performance (p. 62). When a
patch with Matrix Control settings is assigned to a part, confirm that any MIDI messages used for the Matrix Control will be received. If the
JUNO-Di is set up such that reception of MIDI messages is disabled, then the Matrix Control will not function.
KEY RANGE
Parameter Value Explanation
FADE LOWER 0–127
Determines what will happen to the tone’s level when a note that’s lower than Key Range Lower
is played.
If you don’t want the tone to sound at all, set this parameter to “0.”
LOWER C-1 –(UPPER) Specifies the lowest note that the tone will sound for each tone.
UPPER (LOWER)–G9 Specifies the highest note that the tone will sound for each tone.
FADE UPPER
0–127
Determines what will happen to the tone’s level when a note that’s higher than Key Range
Upper is played.
If you don’t want the tone to sound at all, set this parameter to “0.”
MATRIX CONTROL
Parameter Value Explanation
SOURCE 1–4
OFF,
CC01–31, 33–95,
PITCH BEND,
AFTERTOUCH,
SYS-CTRL1–4,
VELOCITY,
KEYFOLLOW,
TEMPO, LFO1,
LFO2, PITCH ENV,
TVF ENV, TVA ENV
MIDI message used to change the tone parameter with the Matrix Control
OFF: Matrix control will not be used.
CC01–31, 33–95: Controller numbers 1–31, 33–95
PITCH BEND: Pitch Bend
AFTERTOUCH: Aftertouch
SYS-CTRL1–4: Controllers that are shared by the entire JUNO-Di (see TIP below)
VELOCITY: Pressure you press a key with
KEYFOLLOW: Keyboard position with C4 as 0
TEMPO: The specified tempo of the JUNO-Di or the tempo of an external MIDI sequencer.
LFO1: LFO 1
LFO2: LFO 2
PITCH ENV: Pitch envelope
TVF ENV: TVF envelope
TVA ENV: TVA envelope
Key Range Lower
Key Range Upper
Key Fade Lower Key Fade Upper
Level
The tone sounded
in the lower range The tone sounded
in the upper range
Pitch