58
Chapter 5 Using Pedals to Control the Effects
2.
Press PARAMETER [
] [
] to select one of the
Assigns from Assign 1–8.
The Quick Settings selection screen appears in the display.
fig.05-080d
3.
Press ASSIGN [VARIABLE] to set the selected Assign
to “On.”
Each time ASSIGN [VARIABLE] is pressed it alternately
switches this on and off. “ASSIGN” flashes in the display
when the Assign is switched off.
4.
Turn the PATCH/VALUE dial to select the Quick
Settings.
5.
To use the Quick Settings with other Assigns, repeat
Steps 2–4.
Even when using this procedure, the settings selected in
Step 4 are maintained as is and carried over to the Quick
Settings for the next effect.
6.
Press [EXIT] to return to the Play screen.
7.
To save the settings, use the Write procedure (p. 22).
Manual Settings
Here, you can individually determine which controller is to
control which parameter.
fig.05-099
1.
Press ASSIGN [VARIABLE].
2.
Press PARAMETER [
] [
] to select one of the
Assigns from Assign 1–8.
3.
Press ASSIGN [VARIABLE] to set the selected Assign
to “On.”
Each time ASSIGN [VARIABLE] is pressed it alternately
switches this on and off. “ASSIGN” flashes in the display
when the Assign is switched off.
* Be sure to set any Assign settings not being used to “Off.”
4.
Press PARAMETER [
] [
] to display the
following screens.
(Example) With ASSIGN 1
fig.05-100d
5.
Rotate the PATCH/VALUE dial to change the setting’s
value.
6.
Repeat Steps 4 and 5 as needed.
7.
To use other Assigns, repeat Steps 2–6.
Display
Explanation
Quick ASSIGN
- - -: User Setting
Current Setting
Quick ASSIGN
U**:
Quick ASSIGN
P**:
Preset Quick Setting
U**-* ASSIGN
Patch Name
User Patch
P**-* ASSIGN
Patch Name
Preset Patch
When you select a User patch or Preset patch, you can use the
existing patch's assign settings just as they are.
(Example)
1,3
5
2,4
8
Quick Setting
Target
Target Range: Min
Target Range: Max
Source
Source Mode
Active Range Low
Active Range High
GT-8_e.book 58 ページ ２００７年６月２９日 金曜日 午後３時５５分
