32
Chapter 4 Introduction to Effects and Parameters
6.
When layering recordings, repeat Steps 4 and 5.
* The recorded content is cleared when the Type or patch is
switched to a different setting or when the power is turned off.
7.
Adjust the volume.
Adjust the volume of the playback sound with the
LEVEL knob.
8.
When returning to the recording standby, hold down
the Number pedal for the same length of time as the
recording.
The unit returns to recording standby, and the pedal’s
indicator flashes at a fixed interval.
* When playback is stopped, the recorded content is erased.
* To start recording again, wait 2.8 seconds, then carry out step
4.
Hold Delay is functional only in the Play screen.
You can return to the recording standby immediately by
using the CTL pedal or external foot switch.
When using the CTL pedal or external foot swich, set the
following settings to “Hold delay Stop.”
• “Setting the Operation of the CTL Pedal (CTL Pedal
• “Setting the Operation of the EXP Pedal Switch (EXP
• “Setting the Operation of External Foot Switches (Sub
• “Setting the Operation of the CTL Pedal, EXP Pedal
Switch, and EXP Pedal (Assign CTL/EXP)” (p. 56)
• “Setting the Operation of the GT-8 and External
Controllers (Assign Variable)” (p. 57)
CHORUS
In this effect, a slightly detuned sound is added to the
original sound to add depth and breadth.
Parameter/
Range
Explanation
On/Off
Off, On
Turns the CHORUS effect on/off.
Mode
Mono, Stereo1, Stereo2 Selection for the chorus mode.
Mono
This chorus effect outputs the same sound from both L and R.
Stereo1
This is a stereo chorus effect that adds different chorus sounds to L
and R.
Stereo2
This is a stereo chorus effect produced by synthesizing the spatial
characteristics of the direct sound and the effect sound.
Rate
0–100,
BPM
–BPM
Adjusts the rate of the chorus effect.
* When set to BPM, the value of each parameter will be set according to
the value of the Master BPM (p. 51) specified for each patch. This makes
it easier to achieve effect sound settings that match the tempo of the
song (synchronizing the cycle to one-half or one-fourth of the BPM
when the set cycle rate is increased).
When setting to BPM, press PARAMETER [
] several times to
display the Master BPM settings screen.
Depth
0–100
Adjusts the depth of the chorus effect.
To use it for doubling effect, set the value to “0.”
Pre Delay
0.0 msec–40.0 msec
Adjusts the time needed for the effect sound
to be output after the direct sound has been
output.
By setting a longer pre delay time, you can obtain an effect that
sounds like more than one sound is being played at the same time
(doubling effect).
Low Cut (Low Cut Filter)
Flat, 55 Hz–800 Hz
This sets the frequency at which the low cut
filter begins to take effect.
This lets you cut the low-end component below the set frequency to
create a clear, distinct low end, thereby bringing out the high end of
the effect. When “Flat” is selected, the low cut filter will have no ef-
fect.
High Cut (High Cut Filter)
700 Hz–11.0 kHz, Flat
This sets the frequency at which the high cut
filter begins to take effect.
This allows you to get a mild effect sound by cutting the high-end
component above the set frequency. When “Flat” is selected, the
high cut filter will have no effect.
Effect Level
0–100
Adjusts the volume of the effect sound.
GT-8_e.book 32 ページ ２００７年６月２９日 金曜日 午後３時５５分
