31
Advanced Uses
Recording
Listening
Deleting
Creating a CD
Editing an SD
Appendices
Convenient
Functions
Information
/
Display
Checkin
g
/
Preparations
Preparing the Remote Control
When shipped from the factory, a coin-type lithium battery is installed in the remote
control unit. To start using the remote control unit, simply pull out the insulating sheet
that extends from the battery compartment.
Install a coin-type lithium battery in the remote control.
fig.remote01-e.eps
* Handle lithium batteries carefully
●
Use only the specified type (model no. CR2025) of lithium batteries. Be sure to insert it
as directed (to ensure correct polarity).
●
Used lithium batteries must be disposed of in compliance with whatever regulations for
their safe disposal that may be observed in the region in which you live.
1
Pull out the battery holder.
2
Insert a lithium battery (CR2025) as shown in the illustration.
3
Replace the battery holder.
Push it inward until it clicks into place.
Replacing the Remote Control’s Battery
Back side of the
remote control
1
2
Battery holder
Press here in the direction of the
arrow while you pull out the holder.
Batteries to use
Lithium battery
(CR2025)
CD-2u_SD-2u_e.book 31 ページ 2013年1月24日 木曜日 午前11時34分