BrightSign Compact
This information applies to a product under development. Its characteristics and specifications are subject to change without notice. Roku assumes no
obligation regarding future manufacturing unless otherwise agreed to in writing.
www.rokulabs.com
© Roku 2008
1080i video: Y from Green jack, Pr from Red jack, and Pb from Blue jack.
1/8” Audio connectors
The Brightsign Compact has one 1/8” female audio connectors. The connector has a stereo audio signal.
The full scale voltage output of the audio is 2V RMS, with no load. The minimum load resistance that
should be connected to the audio output is 5K Ohms. The connector is NOT capable of driving
headphones directly. If you need to drive headphones, look into our Brightsign Expander module, which
can drive 3 sets of 5 Ohm headphones directly.
The audio connector has the following pinout:
Tip: Left audio
Ring: Right audio
Base: Ground for audio signal
HDMI connector
The HDMI connector is used to send digital video and audio to HDMI enabled sink devices. This is the
pinout of the HDMI connector:
pin Description
pin Description
1 TX2p
2 Ground
3 TX2n
4 TX1p
5 Ground
6 TX1n
7 TX0p
8 Ground
9 TX0n
10
TXCp
11 Ground
12 TXCn
13 CEC
14 NC
15
DDC SCL
16
DDC SDA
17 Ground
18 +5V
DDC
19
HPD (Hot Plug Detect)
20
Ground
5V Serial connector
The HD2000 has a single 1/8” female connector 5V serial access. This port is used to communicate with
devices that require 0 and 5V serial signaling.
This connector has the following pinout:
Tip: Receive data
Ring: Transmit data
Base: Ground
