3M™ Streaming Projector SPR1000
46
© 2012 3M. All Rights Reserved.
En
gl
ish
The projector is powered on and the Roku Stick is inserted but the 3M Streaming
Projector displays the No Input Detected screen.
•
You should see a power light on the stick. If you do not, the stick may not be
inserted properly. Try removing the stick and inserting it again.
The status indicator on the projector flashes red.
•
The projector's battery needs to be charged.
I continue to see the bouncing Roku screen and that's all.
•
While the Roku Streaming Stick boots up, you will see the bouncing Roku screen.
Normally the Roku Streaming Stick takes about two minutes to boot up. If the
screen does not change within 10 minutes, try turning off the projector and try
again.
Setting Up the Projector
The projector falls over when I place it on its rear cover.
•
The cover may not be seated properly. There is a tongue on the bottom corner of
the cover. Insert the tongue into the groove on the projector and the rest of the
cover will snap into place.
The image is tinted or discolored.
•
The wall or surface you're projecting onto is colored. Try projecting onto a white
wall or surface.
•
The lens may be dirty. Use a dry cotton swab to clean it off.
