Rohnson R-753, Инструкция по эксплуатации

Страница: 2 / 4

2
●
Do not leave the water kettle unattended during operation. Use only pure water when filling the
container to the desired level, observing the Min. and Max. markings.
●
Overfilling the container may cause danger from boiling water being forced out. Also
beware of the danger of scalding from hot steam being emitted. Therefore, do not touch any
parts of the appliance except the handle during use.
●
The housing becomes hot during use.
●
Caution! During the boiling process and when pouring out hot water, the lid must be kept closed
at all times.
●
The kettle may only be operated with the base provided with the appliance.
●
The appliance must be used only on a heat-resistant, level surface.
●
Do not allow the appliance or its power cord to come into contact with open flames or any hot
surfaces such as hotplates.
●
Do not let the power cord hang free, and keep the cord well away from hot parts of the housing.
●
Always remove the plug from the wall socket,
-in case of any malfunction,
-after use,
-during cleaning of the appliance.
●
No responsibility is accepted if damage results from improper use, or if these instructions are not
complied with.
●
This kettle is intended for domestic use only and not for commercial applications.
●
In order to comply with safety regulations and to avoid hazards, repairs of electrical appliances
must be carried out by qualified personnel, including the replacement of the power cord. If repairs
are needed, please send the appliance to one of our customer service departments.
Thermal safety cut-out
The preset thermal safety cut-out protects the heating element from overheating should the
appliance be erroneously switched on without any water, or if the heating element is calcified.
Once the safety cut-out has switched off the kettle, it must be allowed to cool down sufficiently, or
must be descaled before it is switched on again.
Before using for the first time
●
For reasons of hygiene, discard the first three filling of water.
Boiling water
●
Never remove the water container from the base (or replace it) while the appliance is switched
on.
-Remove the water container from its base.
-Release and open the lid, and fill the container with water to the desired level, observing the Min.
and Max. markings.
-Before closing the lid and placing the container back on its base, ensure that the appliance has
not yet been switched on.
-Insert the plug into a suitable wall socket and press the On/Off switch.
-The boiling process begins. After reaching the boiling point, the appliance is automatically
switched off by the integral steam cut-off device.
-If you want to interrupt the boiling process, set the On/Off switch to its Off position.