Rohm KZS-P, Перевод оригинального руководства по эксплуатации

Страница: 23 / 43

Assembly of the Centric Clamp | 5
KZS-P_KZS-PG 23 / 43
Connection via pipelines
In the case of connection via pipelines, the centric clamp is supplied with
pressure medium via the connections on the basic body.
1 2 5
1 Pressure connection open 5 Connection for sealing air
2 Pressure connection close
5.2.2 Positioning
When positioning, the centric clamp is adjusted either with cylindrical pins or
with clamping sleeves. There are locating holes on the body for the cylindrical
pins and clamping sleeves. The machine table must be equipped with coun-
terparts of the same diameter.
Positioning with cylindrical pins Positioning with clamping sleeves
5.3 Mounting the Centric Clamp
NOTICE
Deformation of the cover.
In the case of excessive actuation pressure, the cover of the centric
clamp may be deformed.
Ø For test purposes, operation of the centric clamp KZS-P/KZS-
PG up to 3 bars is permitted during assembly on the test bench.
Ø From more than 3 bars, the centric clamp must be bolted to the
machine table.