Rohde & Schwarz SMM100A, Руководство пользователя

Страница: 783 / 1088

Remote control commands
R&S
®
SMM100A
783 User Manual 1179.1341.02 ─ 05
[:SOURce<hw>]:BB:DM:PRAMp:BBONly[:STATe] <State>
Enables power ramping in the baseband only or mixed power ramping in the baseband
and the RF section.
The
ON
setting is mandatory if, with power ramping active, only the baseband signal is
output (I/Q outputs).
Only then can a signal with a defined, predictable level be output.
Parameters:
<State> 1 | ON | 0 | OFF
*RST:
0
Example: See Example "Enable power ramping" on page 772.
Manual operation: See "In Baseband Only" on page 127
[:SOURce<hw>]:BB:DM:PRAMp[:STATe] <State>
Enables or disables power ramping.
Parameters:
<State> 1 | ON | 0 | OFF
*RST:
0
Example: See Example "Enable power ramping" on page 772
Manual operation: See "State" on page 126
Trigger settings
[:SOURce<hw>]:BB:DM[:TRIGger]:SEQuence <Sequence>
Selects the trigger mode. For detailed description of the trigger modes, refer to "Impact
of the trigger modes on the signal generation" on page 96.
Parameters:
<Sequence> AUTO | RETRigger | AAUTo | ARETrigger | SINGle
*RST:
AUTO
Example: See Example "Adjusting clock, marker and trigger settings"
on page 772
Manual operation: See "Mode" on page 109
[:SOURce<hw>]:BB:DM:TRIGger:SOURce <Source>
Selects the trigger signal source and determines the way the triggering is executed.
Provided are:
●
Internal triggering by a command (
INTernal
)
●
External trigger signal via one of the local or global connectors
–
EGT1|EGT2
: External global trigger
SOURce subsystem